Sketching

   In this unit of Intro To Engineering, we learned about several different ways of sketching. Oblique, Perspective, and Isometric. It was a fun experience and taught a lot.



This is the oblique pictorials. They
show the faces of an isometric object. You
can show any face of the object.
These were sketched and the width, height, and depth were labeled.
After sketching the oblique pictorials, conclusion questions
were completed.



This is the perspective sketching.  There are three points
in perspective sketching. One point perspective,
two point perspective, and three point perspective. One point
perspective and three point perspective look the same right?
Thats because they are the same object , the three point perspective is just
being sketched at an angle of the one point perspective.

This is the Multi-view sketch. It shows 3 faces of the overall object. It shows the top, right, and front views of the object. In multi-view sketching the depth should be equal as well as the height.

This is the isometric drawing. It shows angles of all of the objects. It has tonal shading on the front and side views but not the top.